#MembraneCleaner
#ROmembraneCLEANINGchemical
#MembraneCLEANER_MuscatOMAN
#membraneCLEANINGchemical_Dubai
#ROcleaningCHEMICALmanufacturer
#AlkalineMembraneCLeanerRO

Dilution - The product must be diluted prior to introduction into the membrane system. The recommended dilution for this product is 500 Grams of ORG MC 511 (Membrane Cleaner) per 20 Ltrs of water.

General Cleaning Instructions

The following general cleaning procedure can be followed. For the optimum cleaning procedure for your system, contact

 Rx Marine International Representative.

1. Inspect cleaning tank, hoses, and cartridge filter. Clean tank and flush hoses if necessary. Install new cartridge filters.
2. Fill cleaning tank with RO permeate or DI water. Turn on agitator or tank recirculation pump.
3. Slowly add ORG MC 511 (Membrane Cleaner)  to cleaning tank 5 Ltrs of product for every 200 Ltrs of water and allow to mix thoroughly.
4. Check solution temperature. If solution temperature is lower than recommended level, adjust heating control to provide optimum temperature. 
5. Check solution pH. The solution pH should be 10 to 11.5 or as recommended by the membrane manufacturer. If pH is too low, adjust pH upward with NaOH, or other chemical as recommended by the membrane manufacturer. If pH is too high, adjust with hydrochloric acid.
6. Circulate solution through one stage at a time in the direction of feed flow for 30 minutes. Circulate at the flow rate recommended by the membrane or system manufacturer. If the manufacturer’s recommendation is not available, contact Rx Marine International representative. Pressure should be low enough so that no permeate is produced during cleaning, but always less than 60 psig (4.2 kg/cm2). In cases of heavy fouling, the first return flow (up to 15% of the cleaning tank volume) should be diverted to drain to prevent redeposition of removed solids. For optimum results, each stage must be cleaned separately in a multistage system.
7. If the first stage cleaning solution becomes turbid or discolored, dump the tank and prepare a fresh cleaning solution before proceeding. If solution pH or temperature move out of the recommended range, a new solution should be prepared. In any event, a new cleaning solution should be prepared for each stage.
8. Rinse with RO permeate before returning system to service.
9. When returning unit to service, divert product water to drain until any residual cleaning solution has been rinsed from system.

• Works well in two-stage cleaning programs with acidic cleaners.
  • Stage 1 (alkaline) → removes organics, oils, biofouling, and iron.
  • Stage 2 (acidic ORG 75 Membrane Clean MC) → removes inorganic scales (CaCO₃, sulfates, etc.).

RO Membrane Cleaner Alkaline manufacturer supplier in UAE, RO Membrane Cleaner Alkaline manufacturer distributor in Oman, RO Membrane Cleaner Alkaline manufacturer exporter in India 

Membrane Cleaner Alkaline manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai, Sharjah, UAE, Gulf, Middle East, Muscat Oman, Kenya Africa. Get the best quality of Membrane Cleaner Alkaline at a competitive price from us. We have ready stock of Membrane Cleaner Alkaline in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.

Useful Applications

Supply & Distribution Locations